Digital Home System DHS-ZW-SNMT-01 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Digital Home System DHS-ZW-SNMT-01. Digital Home System DHS-ZW-SNMT-01 14 pagina's. Z-wave motion sensor

Pagina afdrukken

Con rming con gured parameters

Con guring the Temperature Sensor

NOTE:

The sensor has a few con gurable parameters which determine its behaviour.

The con gurable parameter related to the

Temperature O set - An o set for the temperature in degrees. Default is

zero. Change this parameter only if you need to calibrate the Temperature

Sensor.

Also, you have to change the UPnP les to enable proper integration and presenta-

tion of the Temperature Sensor in Vera. The preinstalled UPnP device for your Tem-

perature Sensor is "TemperatureSensor".

Calibration of the Temperature Sensor, using Temperature O set parameter

1. Open settings box for

"_Motion

Sensor" in Vera dashboard. Go to "Advanced" tab.

2. Click on "Add con guration settings". Fill out the elds:

a. "Variable" – type "6"

b. "Data Size" – choose

"2 byte

c. "Desired Value" – type required

3. Click SAVE in Vera and wait till new settings are saved in Vera.

4. Press the temper button on the device and keep it for 3-7 seconds, then release. This is to

wake up and propagate the settings.

5. Check the con gured values in the eld "Con guredVariable" or "VaraiblesGet" elds on

"Advance Tab" in the Seetings box of the "_Motion Sensor".

Selecting UPnP con guration les for the Temperature Sensor

NOTE:

Your Temperature sensor is a child device - of the parent device "_Motion Sensor". Out

of two "_GenericIO" devices the one with the

The altid number you can nd under "Advanced" tab of the setting box.

1. Open settings box for "_GenericIO" with altid=e1 in Vera dashboard. Go to "Device Op-

tions" tab.

2. Replace the content of the following two elds with the values provided below:

device_type = urn:schemas-micasaverde-com:device:TemperatureSensor:1

device_ le = D_TemperatureSensor1.xml

Temperature Sensor

is:

hex"

Temperature O set

value, e.g. 5

altid=e1

is your Temperature Sensor.