Siemens CD914GX 1 Series Gebruikershandleiding en installatie-instructies - Pagina 23
Blader online of download pdf Gebruikershandleiding en installatie-instructies voor {categorie_naam} Siemens CD914GX 1 Series. Siemens CD914GX 1 Series 44 pagina's.
Pagina afdrukken
16.1 Malfunctions
Fault
The appliance is not
working.
Appliance is switched
on but controls not
responding;
ap-
pears on the display.
Appliance does not
heat up.
A message with "D"
or "E" appears in the
display, e.g. D0111
or E0111.
The operation does
not start or is inter-
rupted.
Appliance prompting
you to wipe down
cooking compartment
and fill water tank.
After an operating
mode is switched on,
a message on the
display indicates that
the temperature is
too high.
Buttons are flashing.
Liquid in evaporator
dish completely evap-
orated even though
water tank full.
Water tank emptying
for no reason and
evaporator dish over-
flowing.
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
Childproof lock is activated.
▶
Press and hold the
Demo mode is switched on.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
→ "Changing the basic settings", Page 16
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
Malfunction
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
Appliance door not fully closed.
▶
Close appliance door.
Appliance is not active.
▶
Switch the appliance off and then on again.
The power supply has been disconnected or the appliance has been switched off during the
descaling process.
▶
When you switch the appliance back on, rinse it twice.
Appliance has not cooled down sufficiently.
1.
Allow the appliance to cool down.
2.
Select an operating mode once again.
Normal occurrence caused by condensation behind the control panel.
No action required.
Water tank not inserted correctly.
▶
Slide the water tank in until it clicks into place.
Supply line to water tank blocked.
1.
Descale the appliance.
2.
Check and adjust the set water hardness range.
▶
If the orange-coloured plugs are still inserted in the tank guide housing, remove the
plugs.
The plugs are no longer required.
Water tank not closed properly.
▶
Close water tank lid and press down until it clicks into place.
Tank lid seal dirty.
▶
Clean the seal.
Tank lid seal defective.
▶
Buy a new water tank from our after-sales service.
button until
goes out on the display.
Troubleshooting en
23