Siemens CM724G1B1 Gebruikershandleiding en installatie-instructies - Pagina 27
Blader online of download pdf Gebruikershandleiding en installatie-instructies voor {categorie_naam} Siemens CM724G1B1. Siemens CM724G1B1 44 pagina's.
Pagina afdrukken
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up.
The time is not dis-
played when the ap-
pliance is switched
off.
Home Connect is not
working properly.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
Cause and troubleshooting
Electronics fault
1.
Briefly disconnect the appliance from the power supply by switching off the fuse.
Reset the basic settings to the factory settings.
2.
→ "Basic settings", Page 19
There has been a power cut.
Configure the initial configuration settings.
▶
→ "Performing initial start-up", Page 12
Different causes are possible.
Check the notifications that appear on the display.
▶
→ "Displaying information", Page 13
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 28
Demo mode is switched on.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
1.
the fuse box off and then on again.
Switch off demo mode in the basic settings within approx. 5 minutes.
2.
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 19
Different causes are possible.
Go to www.home-connect.com.
▶
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600 W
or 900 W. The cooking result is not affected by this.
You can change the basic setting for the drying function during microwave operation.
▶
→ "Basic settings", Page 19
Observe the information on operating with microwave.
‒
→ "Microwave", Page 15
The LED light is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 28
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
To continue operation, switch the appliance off and on again using
1.
the operation.
2.
If you do not need to use the appliance, press
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Time-setting options", Page 14
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 28
Troubleshooting en
. Reset and start
to switch it off.
27