Digital Home Systems DHS-CON-KFB-VIS-04 Snelle installatiehandleiding - Pagina 2
Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} Digital Home Systems DHS-CON-KFB-VIS-04. Digital Home Systems DHS-CON-KFB-VIS-04 2 pagina's. Vision z-wave keyfob
Pagina afdrukken
1
Installation
Charging
Use the supplied charger cord to charge the keyfob, proceed with in this guide only
after the keyfob is fully charged (The LED indicator should be Green)
Inclusion/exclusion into a Z-Wave network
Include or exclude method
First Ensure that the switch at the bottom of the Device is set to Control mode not
Set-up mode
1. Make sure your Z-Wave home controller is in the right operation mode (include or
exclude), this can be done by pressing add device under Devices and selecting Generic
Z-Wave device then follow the prompts.
2. Upon reaching step 3 of the set-up wizard, press and hold buttons 1 and 4 on the
keyfob until the Red LED flashes and the Vera Edge UI should confirm that the keyfob
has been added.
3. After the Vera has finished including the Keyfob into the system press and hold
buttons 2 & 3 on the keyfob until the Green LED flashes so that Vera can complete the
configuration of the device.
2
Operation
1.
For ease of use ensure that the keyfob is set to Scene Activation Mode this is
done by holding down buttons 1 and 3 until the Red LED flashes.
Go into the keyfob's button options by clicking "Select scenes for device
2.
buttons" in the keyfob's settings page. (You should be prompted to put in how
many buttons the device has, as the keyfob supports short presses and long
presses you will need to put 8 into the box and click save).
3.
After clicking save the UI should show that you have 8 buttons.
4.
Create a scene that you wish to activate via the keyfob controller and assign it
to the relevant button you wish, keeping in mind that every even button (2-4-
6-8) are activated by holding down the buttons on the keyfob.
If scenes are not triggering at they are meant to such as button 3 is activating
button 1 scenes, please follow BUTTON CONFIGURATION ERROR found
on the troubleshooting page of this manual.
All On/All Off
1.
To turn all associated devices on press and hold buttons 1 and 2 until the
Green LED flashes once.
2.
To turn all associated devices off press and hold buttons 3 and 4 until the Red
LED flashes once.
3
Troubleshooting
NOTE: Before including the product to your Z-Wave network it is advised to
perform the exclusion procedure to reset network settings.
Button Configuration Error
Recently the Vera Edge has been causing a configuration error on Visions Keyfobs
If your Scenes are not triggering correctly such as button 1's Scene being triggered by
button 3-4 please refer to the Button Configuration Error guide.
This device is using a radio signal that passes through walls, windows and doors. The
range can be influenced by local conditions such as large metal objects, house wiring,
concrete, furniture, refrigerators, microwaves and similar items. On average, the
indoor range is approximately 12- 30 meters.
Do not expose this product to excessive heat or moisture.
Prevent long term exposure to direct sunlight.
Do not attempt to repair this product. If the product is damaged or if you are in doubt
about the proper operation, take the product back to the place of purchase.
Do not clean the product with any liquid.
Do not paint.