Siemens Silver WD 1000 TOP WD 1200 Bedienings- en installatie-instructies - Pagina 12
Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Siemens Silver WD 1000 TOP WD 1200. Siemens Silver WD 1000 TOP WD 1200 28 pagina's.
en
Detergents and fabric-care additives
Fig. 11 , 12
You can use detergent which is suitable for
front loading automatic washing machines.
! Never use detergents for impeller type as
these produce too much foam.
! Never use solvent-based cleaning agents in
fully automatic washing machines. Explo-
sion hazard.
! Do not use any detergent boosters contai-
ning solvents or dirt and stain-removing
sprays near the machine, as these could
damage the machine.
! Always store detergents and other garment-
care products out of children s reach.
Amount of detergent
The best washing results will only be achieved
if you add the correct amount of detergent.
Observe the instructions for use shown on the
detergent packaging.
If a liquid detergent is used, take the relative
dosing device. Do not fill the detergent dispenser
beyond the MAX mark.
You can also use any measuring aids provided
with the detergents, such as dosage balls or
bags.
The amount of detergent depends on:
- water hardness
- degree of soiling
- size of the load
- amount of detergent to be added according
to its manufacturer.
Attention: When the prewash mode is selected,
do not put the liquid lotion or other liquid materials
into the compartment II, to prevent it from flowing
out immediately.
10
,
Frequent use of insufficient detergent will even-
tually become noticeable as follows:
- washing appears grey or not properly clean
- grey-brown stains (grease marks) appear on
the washing
- the heating elements become furred.
Too much detergent results in:
- unnecessarily high environmental pollution,
- as too much foam is produced, you will get
poor washing results.
The amount of detergent indicated on its
packaging refers to a full machine load.
For smaller loads or less soiled laundry, reduce
the amount of detergent.
Notes
Fabric softeners and conditioners
Put these into the
beyond the MAX mark otherwise it will flow into
the machine together with the detergent at the
start of the programme. Dilute thick conditioner
with a little water (make sure to dissolve all lumps)
before pouring it into the
Bleaching agents and stain removers
In addition, certain powdered bleaching agents
and stain removers may be used on stained
fabrics.
First put the detergent and then the bleaching
powder or stain remover into compartment II.
compartment. Do not fill
compartment.