Siemens iQ500 SN56M592AU/82 Gebruiksaanwijzing - Pagina 19

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Siemens iQ500 SN56M592AU/82. Siemens iQ500 SN56M592AU/82 36 pagina's.

Pagina afdrukken
Operating
the appliance
a n c e
a p p l i
n g t h e
O p e r a t i
A qua sensor *
Aq u a s e n s o r
* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.

Switching on the appliance

1. Turn on the tap fully.
2. Switch on ON/OFF switch (.
The display of the last selected
programme flashes. This programme
remains selected if no other
programme button 0 is pressed.
The expected programme duration
flashes on the digital display )".
3. Press the START button `.
The programme starts running.
P rogramme sequence
Pr o g r a m m e s e q u e n c e in d i c a t o r
indicator h
-/,
Your dishes are being
cleaned.
5/%
Your dishes are being rinsed.
=/<
Your dishes are being dried.

Operating the appliance

Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )".
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).

Timer programming *

Ti m e r pr o g r a m mi n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display )" jumps to :
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
6. To delete timer programming, press
the P + or – button until )" :
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value :
is indicated on the numerical
display )".
aus
.
19