Cisco Unified IP Phone Does not Register with Cisco Unified Communications Manager
Solution
The following suggestions can help determine if the phone is functional:
1. Verify that the network port is functional:
2. Verify that the phone is receiving power:
3. If the phone still does not start up properly, power up the phone with the handset off-hook. When the
phone is powered up in this way, it attempts to launch a backup software image.
4. If the phone still does not start up properly, perform a factory reset of the phone. For instructions, see
Perform Factory Reset, on page
If after attempting these solutions, the LCD screen on the Cisco Unified IP Phone does not display any
characters after at least five minutes, contact a Cisco technical support representative for additional assistance.
Cisco Unified IP Phone Does not Register with Cisco Unified Communications Manager
If the phone proceeds past the first stage of the startup process (LED buttons flashing on and off) but continues
to cycle through the messages displaying on the LCD screen, the phone is not starting up properly. The phone
cannot successfully start up unless it is connected to the Ethernet network and it has registered with a
Cisco Unified Communications Manager server.
In addition, problems with security may prevent the phone from starting up properly. See
Phone Security Problems, on page 8
Phone Displays Error Messages
Problem
Status messages display errors during startup.
Solution
As the phone cycles through the startup process, you can access status messages that might provide you with
information about the cause of a problem. See
messages and for a list of potential errors, their explanations, and their solutions.
Troubleshooting and Maintenance
2
• Exchange the Ethernet cables with cables that you know are functional.
• Disconnect a functioning Cisco Unified IP Phone from another port and connect it to this network
port to verify the port is active.
• Connect the Cisco Unified IP Phone that will not start up to a different network port that is known
to be good.
• Connect the Cisco Unified IP Phone that will not start up directly to the port on the switch, eliminating
the patch panel connection in the office.
• If you are using external power, verify that the electrical outlet is functional.
• If you are using in-line power, use the external power supply instead.
• If you are using the external power supply, switch with a unit that you know to be functional.
21.
for more information.
Status Messages Screen
Troubleshooting and Maintenance
Cisco Unified IP
for instructions about accessing status
Pagina afdrukken