Siemens SX Series Gebruiksaanwijzing - Pagina 30

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Siemens SX Series. Siemens SX Series 48 pagina's. Dishwasher
Ook voor Siemens SX Series: Bedieningsinstructies (38 pagina's), Gebruiksaanwijzing (38 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (46 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (40 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (40 pagina's)

Pagina afdrukken
Siemens SX Series Gebruiksaanwijzing
en Operating the appliance

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.

Terminating the programme

(Reset)
Press the START button P and
1.
p r o g r a m m e
T e r m i n a t i n g t h e
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window )". The
programme sequence lasts about
1 minute. The value ‹:‹‹ appears in
the display window )".
Switch off ON/OFF switch (.
2.
30

Changing the programme

When the START button P has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).

ExtraDry

The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Be careful if you have delicate
tableware)
Here's how to change the setting:
Switch on ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button P until •:‹...
appears in the display window )".
Release both buttons.
3.
The LED of the # button flashes
and the digital display )" shows
the factory setting •:‹....
Press the programme button #
4.
repeatedly until the factory setting
value š:‹‹ appears in the display
window )".
By pressing the 3 button you can
5.
switch intensive drying on š:‹‚ or
off š:‹‹.
Press START button P.
6.
The set value is saved.