Siemens SX Series Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Siemens SX Series. Siemens SX Series 40 pagina's. Dishwasher
Ook voor Siemens SX Series: Bedieningsinstructies (38 pagina's), Gebruiksaanwijzing (38 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (46 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (48 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (44 pagina's), Gebruiksaanwijzing (40 pagina's)

Pagina afdrukken
Siemens SX Series Gebruiksaanwijzing
en
Rinse aid
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
12

Setting amount of rinse aid

The amount of rinse aid dispensed can
be set in 4 stages. Accordingly 0, 1, 2
or 3 displays are lit (see water hardness
table).
Factory setting: 2.
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
4. Release buttons.
5. Keep pressing button > P until
the rinse aid refill indicator )"
flashes.
The rinse aid refill indicator )"
flashes and the displays #
and + are lit (= Setting 2).
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays ` and )" go out.
The selected setting is saved.
3. Close the door.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator )" is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse aid" and select
setting 0.
The rinse aid refill indicator )" is now
switched off.