Cisco 8832 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco 8832. Cisco 8832 20 pagina's. Masergy ip conference phone
Ook voor Cisco 8832: Masterhandleiding voor firmwaremigratie (31 pagina's), Snelstarthandleiding (2 pagina's), Handmatig (30 pagina's), Installatiehandleiding (39 pagina's), Snelstarthandleiding (16 pagina's), Onderhoudshandleiding (9 pagina's), Snel aan de slag (2 pagina's), Instellingen (14 pagina's), Snelstarthandleiding (2 pagina's), Herconfiguratiehandleiding (2 pagina's), Snel aan de slag (2 pagina's), Handmatig (30 pagina's)

Disconnect the wired expansion microphones before you install wireless expansion microphones. You cannot use

both wired and wireless expansion microphones at the same time.

Procedure

Step 1 Position the table mount plate on the table surface location where you want to place the microphone.

Step 2 Remove the adhesive for the double-stick tape on the bottom of the table mount plate. Place the table

mount plate to adhere to the table surface.

Step 3 Attach the microphone to the table mount plate. Magnets are embedded in the microphone to snap the

unit into place.

You can move the microphone and attached table mount to a different location on the table surface as

needed. Use care when moving to protect the unit.

Pair a Wireless Microphone

Before you begin

Unplug any wired microphones.

Procedure

Step 1 Press Settings.

Step 2 Select Device administration > Microphones > Wireless microphones.

Step 3 Select either Microphone 1 or Microphone 2 and press Pair.

If a microphone is already linked to a particular channel, the phone screen shows that the microphone is

paired.

Step 4 Press Mute

succeeds, the phone screen displays a success message.

Step 5 (Optional) Press Cancel to revert to the Wireless microphones menu.

Unpair a Wireless Microphone

Procedure

Step 1 Press Settings.

Step 2 Select Device administration > Microphones > Wireless microphones.

Step 3 Select either Microphone 1 or Microphone 2.

If the selected channel is paired, the Unpair softkey displays on the phone screen.

Step 4 Press Unpair.

Install the Wireless Microphone Charging Cradle

You use the charging cradle to charge the wireless microphone battery.

Procedure

Step 1 Plug the charging cradle power adapter into an electrical outlet.

Step 2 Plug one end of the USB-C cable to the charging cradle and the other end into the power adapter.

The following figure shows installation of a wireless microphone charging cradle.

Figure 4: Wireless Microphone Charging Cradle Installation

4 |

P a g e

on the wireless microphone until the microphone LED blinks white. If the pairing

Cisco IP Phone 8832 Series User Guide