Ricoh Plockmatic SquareBack Trimmer Gebruikershandleiding - Pagina 31

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Ricoh Plockmatic SquareBack Trimmer. Ricoh Plockmatic SquareBack Trimmer 45 pagina's. Cip training

Pagina afdrukken
CIP Training Plockmatic SquareBack Trimmer
Troubleshooting
Jam codes list
Code # Area
507
Infeed
508
Infeed
509
Infeed
510
Infeed
511
Infeed
512
Infeed
600
Trimmer
601
Align
602
Align
603
Align
604
Clamper
605
Clamper
606
Align
607
Exit
608
Exit
609
Exit
610
Align / Clamper Q15 and Q16 (paper path sensors) covered too long.
611
Align / Clamper Q15 and Q16 (paper path sensors) covered after purge.
612
Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered too long.
613
Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered after purge.
614
Align / Clamper Q16 and Q17 (paper path sensors) covered too long.
615
Align / Clamper Q16 and Q17 (paper path sensors) covered after purge.
616
Stacker
701
Waste bin
Clearing a jam condition
The trim unit has two sharp knives for trimming booklets: do not touch them for
any reason and at any time. If service is needed, call a technician.
If any of the jams listed in the table above is triggered, please follow these guidelines:
•
Open the top covers and remove any booklet stuck in the paper path;
•
Check for misfed sheets and remove them;
•
Check for debris on the paper path and remove them;
•
Check that booklets on the stacker do not block path of exiting booklets;
•
Ensure there are no obstructions in the paper path;
•
Wipe all sensors (do not use any fluid to clean them);
•
Make sure the paper size is set correctly;
•
Power off and power on the machine.
Cause
Q13 and Q14 (paper path sensors) covered too long.
Q13 and Q14 (paper path sensors) covered after purge.
Q13, Q14 and Q15 (paper path sensors) covered too long.
Q13, Q14 and Q15 (paper path sensors) covered after purge.
Q14 and Q15 (paper path sensors) covered too long.
Q14 and Q15 (paper path sensors) covered after purge.
Booklet has missed Q15 or did not go past Q15, Q16 or Q17.
Q15 (paper path sensor) not reached in time.
Q15 (paper path sensor) covered too long.
Q15 (paper path sensor) covered after purge.
Q16 (paper path sensor) not reached in time.
Q16 (paper path sensor) covered too long.
Q16 (paper path sensor) covered after purge.
Q17 (paper path sensor) not reached in time.
Q17 (paper path sensor) covered too long.
Q17 (paper path sensor) covered after purge.
Stacker is full.
Waste bin is full.
WARNING: