Ricoh SP 1210N Handleiding voor snelle installatie - Pagina 25
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Ricoh SP 1210N. Ricoh SP 1210N 28 pagina's. Quick installation guide
Ook voor Ricoh SP 1210N: Snelle installatiehandleiding (2 pagina's)
Pagina afdrukken
Setting your IP address, Subnet
Mask and Gateway using BRAdmin
Light
Note
If you have a DHCP/BOOTP/RARP server in your
network, you don't have to do the following
operation. Because the print server will
automatically obtain its IP address.
1
Start BRAdmin Light. It will search for new
devices automatically.
2
Double-click the unconfigured device.
3
Choose STATIC for the Boot Method. Enter
the IP Address, Subnet Mask and Gateway,
and then click OK.
4
The address information will be saved to the
printer.
For Network Users
Network default settings
2
To restore all network settings of the internal print
server to default, follow the steps below.
1
Turn off the printer.
2
Make sure that the front cover is closed and the
power cord is plugged in.
3
Hold down the Go button as you turn on the
power switch. Keep the Go button pressed
down until the Toner, Drum and Error LEDs
light up. Release the Go button. Make sure that
all the LEDs turn off.
4
Press the Go button seven times. Make sure
that all the LEDs light up when the print server
has been reset to its default factory settings.
Print the Printer Settings
3
Page
The Printer Settings Page lists all the current printer
settings, including network settings. To print the
printer settings page:
1
Make sure that the front cover is closed and the
power cord is plugged in.
2
Turn on the printer and wait until the printer is
in the Ready state.
3
Press the Go button three times within 2
seconds. The printer will print the current
printer settings page.
23