Ricoh 77751 Servicehandleiding - Pagina 5

Blader online of download pdf Servicehandleiding voor {categorie_naam} Ricoh 77751. Ricoh 77751 13 pagina's.

Pagina afdrukken

Outline of Assemble and Disassemble

1. Caution

1. Be sure to use the anti-static mat and wrist strap to prevent static failure of circuits.

2. This product is used lead free solder.

Surface of solder will be white-tinged color. Solder quickly, because melting temperature is high and so if

heat too much, it is possible to damage to PC board. Soldering iron requirement: The temperature can be

adjusted up to 400℃ and exclusive use for lead free solder. Also it is desirable to use antistatic soldering

iron. The temperature for tip of soldering iron must set between 340℃～360℃ for lead free solder.

3. Do not stress to the connector terminals and flexible boards because they are very delicate parts. Pay

careful attention to the connector terminals and flexible boards and, we recommend marking to the flexible

board before disconnecting them. This will be helpful to reconnect the flexible board to the connector

terminal properly.

4．Paste parts of that tape and etc. Follow the instructions in the service manual paste, so there is no float or

drift. Specially, there is a risk of a short copper foil tape and gaskets to connector.

（If adhesive tape of glue weaken, it must replace to new one.）

2. Flow chart for assembling body and Front housing

*The same as K-30(77650)

III. Assembling body

1． E000 (Shutter block)

2． 0-A101 (Front housing)

3． A6 (Upper L plate)

4． T700 (Upper flex P.C. board)

5． T980 (RAW SW board)/T940(AF select SW board)

6． A4(R Plate)

7． T750 (Flash flex board)

8． T901 (Lower flex P.C. board)

9． 0-A51 (Tripod plate)

10. [Conf] Height of SR Base Plate Support Pillar

11. 0-C000 (SR Block)

12. [Adj.] Height of 0-C000

13. T100 (Main P.C. board)

14. [Adj.] J100 position

15. 0-M311 (Eyepiece frame)

16. A150 (Front cover) /A201(Back cover)

...If M100 adjust, attached temporary cover(A150)

17. A301 (Top cover)

18. A401 (Bottom cover)

...If M100 adjust, attached temporary cover(A401)

19. [Adj.] AF-CCD position

II. Front housing block

1．A101 (Front main body assy)

2．A104 (Mount ring)

3．[Adj.] AF joint stroke

4．0-B52 (Mirror part)

5．[Adj.] First/second mirror angle

6．S250 /G100(Mirror motor part)

7．[Conf] Mirror function

8．Penta mirror part (M27)

9．[Adj.] Finder focus/Parallax

10. Finder part (O100)

11. [Adj.] O100 position

12. M100 (AF Block)

13. J100 (Photo sensor block)

14. M51, O170 (SI Block)

15. [Adj.]SI-LED position

[Ⅳ

77750 - 4/12 -

Adjustment/Confirmation]