Cisco 1751 Snelstarthandleiding - Pagina 11

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 1751. Cisco 1751 35 pagina's. Modular access router
Ook voor Cisco 1751: Oplossingsoverzicht (16 pagina's), Gegevensblad (19 pagina's)

Pagina afdrukken

If the installer does not start after a few seconds, select Start>Run, and enter d:\setup where d is your

CD-ROM drive.

Step 5

Follow the instructions on the screen to install the Cisco ConfigMaker application.

To learn about the Cisco ConfigMaker application, view the online movie, or use Cisco ConfigMaker

Help Topics from the help menu.

You need administrative privileges to install the Cisco ConfigMaker application on Windows NT.

Cisco IOS Command-Line Interface

To configure your router from the command-line interface (CLI), refer to this guide, the Cisco 1700

Series Software Configuration Guide, or the Cisco 1751 Router Software Configuration Guide available

on the Documentation CD-ROM.

Major Voice over IP Configuration Tasks

Follow these major steps to configure Voice over IP (VoIP) on your router:

Configure your IP network to support real-time voice traffic. Before you move to the next step, ping the

Step 1

remote router to make sure you have an IP connection.

Configure your router to support voice ports. Follow these steps for your specific requirements:

Step 2

•

Enter configuration mode to configure your router for VoIP traffic. Refer to the

Step 3

Voice-over-IP" section on page

Save the configuration. Refer to the

Step 4

Establish a dial plan to determine how the call can be routed. Use the dial-peer voice command to define

Step 5

dial peers and to implement the dial plan. Refer to the

Fine-tune your network to adequately support VoIP by configuring a series of protocols and features for

Step 6

quality of service (QoS). Refer to the

page

78-11259-05

Foreign exchange station (FXS) and foreign exchange office (FXO) voice ports

The default voice-port values are usually adequate for both FXS and FXO voice ports. However, if

you need to change the default values, refer to the Cisco 1751 Router Software Configuration Guide.

E&M voice port

The default values for an E&M voice port are not sufficient to enable voice and data transmission

over the IP network. E&M values must match those of the connected PBX device. Refer to the

"Connecting the FXS, FXO, and E&M VICs to the Network" section on page

ISDN BRI port

The default values for a basic rate interface (BRI) port are not sufficient to enable voice and data

transmission over the IP network. BRI values must match those of the connected PBX device. Refer

to the

"Connecting the FXS, FXO, and E&M VICs to the Network" section on page

25.

10.

"Saving the Configuration" section on page

"Dial Plan" section on page

"Tuning Parameters for Real-Time Voice Traffic" section on

Cisco 1751 Voice-over-IP Quick Start Guide

Configuring Voice-over-IP

"Configuring

13.

14.