Cisco 1800 Series Snelstarthandleiding - Pagina 19

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 1800 Series. Cisco 1800 Series 28 pagina's. Cisco ios software configuration
Ook voor Cisco 1800 Series: Gegevensblad (16 pagina's), configureren (32 pagina's)

Pagina afdrukken

Initial Configuration Using Setup Command Facility

This section shows how to use the setup command facility to configure a hostname for the router, set passwords, and configure

an interface for communication with the management network.

If the following messages appear at the end of the startup sequence, the setup command facility has been invoked automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it creates an initial

configuration file. After the configuration file is created, you can use the CLI or Cisco Router and Security Device Manager to

perform additional configuration.

The prompts in the setup command facility vary, depending on your router model, the installed interface modules, and the

software image. The following example and the user entries (in

For help with interface and port numbering, see the "Interface Numbering" section on page 17.

Note

If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.

Press Ctrl-C, and enter the setup command at the privileged EXEC mode prompt (Router#).

Step 1

To proceed using the setup command facility, enter yes:

Would you like to enter the initial configuration dialog? [yes/no]: yes

Step 2

When the following messages appear, enter yes to enter basic management setup:

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Step 3

Enter a hostname for the router (this example uses Router):

Configuring global parameters:

Enter host name [Router]: Router

Step 4

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

configuration:

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 5

and can be seen when viewing the configuration:

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password: xxxxxx

) are shown as examples only.

bold