Cisco 2500 Series Aan de slag handleiding
Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco 2500 Series. Cisco 2500 Series 47 pagina's. Wireless controller
Ook voor Cisco 2500 Series: Handleiding installeren (12 pagina's), Configuratiehandleiding (19 pagina's), Uitrolhandleiding (23 pagina's), Configuratiehandleiding (50 pagina's)
Pagina afdrukken
Cisco 2500 Series Wireless Controller
Getting Started Guide
First Published: May 2011
About This Guide
This guide is designed to help y192.0.2.1ou install and minimally configure your Cisco 2504 Wireless
Controller (2504 controller), which is part of the Cisco 2500 Series Wireless Controllers.
FCC Safety Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on.
Try to correct the interference by one or more of the following measures:
•
•
•
•
Safety Information
Safety warnings appear throughout this guide in procedures that may harm you if performed incorrectly.
A warning symbol precedes each warning statement. The warnings below are general warnings that are
applicable to the entire guide. Translated versions of the safety warnings in this guide are provided in
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. (cfr reference 15.105)