Cisco 2501 - Router - EN Configuratiehandleiding - Pagina 4
Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco 2501 - Router - EN. Cisco 2501 - Router - EN 19 pagina's. Access server - chapter 4
Ook voor Cisco 2501 - Router - EN: Gebruikershandleiding (11 pagina's)
Pagina afdrukken
Booting the Access Server for the First Time
•
Software version level and hardware configuration (enter the show version command
to display this information)
•
Software configuration (enter the show running config (Release 11.0 or later) or the
write terminal command (Earlier than Release 11.0) to display this information)
Contacting the European Technical Assistance Center
Cisco and its European Service Partners coordinate all customer service in Europe,
including hardware and software telephone technical support, onsite service, and module
exchange and repair. For more information, contact the European TAC.
European TAC numbers and e-mail address are as follows:
•
Phone: 32 2 778 42 42
•
Fax: 32 2 778 43 00
•
E-mail:
Booting the Access Server for the First Time
The access server is administered using the Cisco command interpreter, called the EXEC.
You must log in to the access server before you can enter an EXEC command. For security
purposes the EXEC has two levels of access to commands, user EXEC mode and privileged
EXEC mode.
To enter the privileged mode you must enter the enable secret password on systems running
Cisco Internetwork Operating System (Cisco IOS) Release 10.2(3) or later, or the enable
password on systems running Cisco IOS releases prior to 10.2(3) or when using the boot
ROM monitor.
Using the Enable Secret and the Enable Password
The commands available at the user level are a subset of those available at the privileged
level. Because many privileged-level EXEC commands are used to set operating
parameters, you should password-protect these commands to prevent unauthorized use.
4-4 Cisco 2500 Series Access Server User Guide