Cisco 2524 - Router - EN Configuratiehandleiding

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 pagina's. Troubleshooting guide
Ook voor Cisco 2524 - Router - EN: Configuratiehandleiding (23 pagina's), Overzicht (10 pagina's), Voorbereiden op installatie (19 pagina's), Handleiding voor probleemoplossing (4 pagina's)

C H A P T E R

Configuring the Cisco 2524 and

Cisco 2525 Routers

This chapter describes how to configure the Cisco 2524 and Cisco 2525 routers and

contains the following sections:

•

This chapter provides just enough information to get the router up and running. For

Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Configuration

Guide for additional configuration information. For Cisco IOS Release 11.1 and later

releases, refer to the Configuration Fundamentals Configuration Guide.

Booting the Router for the First Time

Each time you power on the router, it goes through the following boot sequence:

Booting the Router for the First Time

Configuring the Router

Specifying the Boot Method

Checking the Configuration Settings

Getting More Information

The router goes through power-on self-test diagnostics to verify basic operation of the

CPU, memory, and interfaces.

The system bootstrap software (boot image) executes and searches for a valid Cisco IOS

image (router operating system software). The source of the Cisco IOS image (Flash

memory or a Trivial File Transfer Protocol [TFTP] server) is determined by the

configuration register setting. The factory-default setting for the configuration register

is 0x2102, which indicates that the router should attempt to load a Cisco IOS image

from Flash memory.

Configuring the Cisco 2524 and Cisco 2525 Routers 4-1