Cisco 2821 - Integrated Services Router Unified Communications Bundle Configuratie - Pagina 7
Blader online of download pdf Configuratie voor {categorie_naam} Cisco 2821 - Integrated Services Router Unified Communications Bundle. Cisco 2821 - Integrated Services Router Unified Communications Bundle 10 pagina's. Overview
Ook voor Cisco 2821 - Integrated Services Router Unified Communications Bundle: Snelstarthandleiding (47 pagina's), Overzicht (27 pagina's)
FastEthernet0/1
Select one of the available interfaces for connecting the router to the management network:
Step 8
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Respond to the following prompts as appropriate for your network:
Step 9
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
Respond to the following prompts. Select [2] to save the initial configuration:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The user prompt appears.
Router>
Verify the initial configuration. See the
Step 11
verification procedures.
OL-5788-01
unassigned
NO
unset
"Verifying the Initial Configuration" section on page 9
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
Configuring the Router
up
dow
for
9