ACDelco I-7005T Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ACDelco I-7005T. ACDelco I-7005T 15 pagina's. Fully automatic microprocessor controlled battery charger for 12-volt lead acid batteries

Pagina afdrukken

System Error. Have the Battery Charger inspected and repaired by a qualiﬁed

Er0

technician.

Reverse polarity connection; there is a bad connection; or the voltage of the battery

Er1

is too low. Verify the polarity and connect the Battery Charger accordingly; verify

that the clamp is connected properly; or replace the battery if necessary.

A cell is shorted; or there is excessive load on the battery. Replace the battery; or

Er2

verify the load.

There is a defective cell or a sulphated plate(s). Run the Maintenance cycle for 24

Er3

to 48 hrs, and then retest the battery. Replace the battery if necessary.

Overheated condition. Turn the Battery Charger 'OFF', and allow it to cool down

for 45 minutes. Verify that that the vents on the Battery Charger's housing are not

Er4

obstructed. Try to use the Battery Charger again, if overheating recurs, replace

the Battery Charger.

Cycle time has been exceeded; or the charge rate setting is too low. The Battery

Charger has been running continuously for 20 hours, and the battery has not taken a

Er5

full charge, which indicates that the battery may be bad. Try charging the battery again.

If the error recurs, replace the battery; set the charge rate to a higher setting.

(In "OPTIMAL CHARGING /REMANAT TIME" MODE)

1. Incorrect CCA value is select. Reset battery's CCA value.

Er5

2. Battery may be bad, replace the battery if its overheat.

NOTE:

When the Er1 Code is detected, proceed with the actions described above. The

Battery Charger should return to 'ON' status when the clamps are reconnected to the battery

posts properly. See the section entitled Operating Instructions in order to select operating

modes or functions. There is no need to reset the 'ON/OFF' button.

STATUS CODE

The power cord is plugged into a 120 V AC power source, and the Battery Charger

OFF

is 'OFF'.

The power cord is plugged into a 120 V AC power source, and the Battery Charger

'On'.

–

– –

Maintenance mode has been activated.

– – –

Reinforced Activation Mode has been activated.

FUL

The Battery is fully charged.

OPTIMIZED CHARGING MODE has been selected. Input the battery's CCA value

CCA

in order to activate the optimized charging and to display the remnant charging

time.

ERROR CODES AND STATUS CODES