Cisco NCS 4000 Series Handleiding uitpakken, verplaatsen en vastzetten - Pagina 23
Blader online of download pdf Handleiding uitpakken, verplaatsen en vastzetten voor {categorie_naam} Cisco NCS 4000 Series. Cisco NCS 4000 Series 40 pagina's. Network convergence system
Ook voor Cisco NCS 4000 Series: Handleiding voor probleemoplossing (44 pagina's)
Pagina afdrukken
Chapter 3
Moving the Chassis
Moving the Cisco NCS 4016 Chassis
This section describes the procedures required to move the Cisco NCS 4016 chassis to its final location.
This section contains the following topics:
•
•
The installation of a Cisco NCS 4016 chassis may require space, floor loading, power, and cooling
Note
modifications to your facility. Site planning should have been performed well in advance of the
scheduled delivery of your system. See the
Planning
Moving Guidelines for the Cisco NCS 4016 Chassis
We recommend that at least two people move the as-shipped chassis from the shipping dock to the
installation site. Make sure that you have at least three people to transport the chassis up and down a
ramp. We also recommend that you leave the as-shipped chassis attached to its pallet for moving. Follow
these guidelines:
•
•
Note
•
•
•
•
If the route to the installation site has any ramps, use a moving device other than a scissor lift to move
Caution
the chassis over the ramps, and then transfer the chassis onto a suitable lifting device such as a scissor
lift for installation. Leave the filler cards in place in empty card slots while you move or install the
chassis in the rack. The filler cards provide support to keep the chassis square during movement and
installation.
Moving Guidelines for the Cisco NCS 4016 Chassis, page 3-5
Moving the Chassis to the Final Location, page 3-6
Guide.
Chassis installation location must be identified.
Packaging should be removed while leaving the chassis firmly secured to the pallet.
To ensure that the chassis has proper access to the installation location, see the
Convergence System 4000 Series Site Planning
Identify the type of suitable moving device that will be used to move the as-shipped chassis from
the loading dock or staging area to the installation site.
Make certain all doorways and hallways are wide and tall enough for the moving the as-shipped
chassis. The Cisco NCS 4016 chassis needs an aisle of approximately 60 inches in width.
Make sure that you have at least one person on each side of the chassis.
When transporting the as-shipped chassis on a ramp, follow these guidelines:
–
Make sure that you have at least three people to transport the chassis up and down a ramp. One
person in the rear pushing, one person at the front pulling, and one steering the chassis.
–
Exercise extreme caution when moving chassis up an incline of any angle.
Cisco Network Convergence System 4000 Series Unpacking, Moving, and Securing Guide
Cisco Network Convergence System 4000 Series Site
Guide.
Moving the Cisco NCS 4016 Chassis
Cisco Network
3-5