CAB 5326C Montagehandleiding - Pagina 13

Blader online of download pdf Montagehandleiding voor {categorie_naam} CAB 5326C. CAB 5326C 15 pagina's. Vacuum-belt applicator

Error Messages

6.1

For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.) " Operator's manual" of the printer

Error treatment:

 Clear the error result

 Press the feed key to synchronize the label feed, remove the excess labels manually

 Press the pause key to quit the error state.

After error correction, the printing of the label causing the error will be repeated.

6.2

The following table contains an overview of error messages and their possible causes. It also suggests methods to

resolve the problems:

Error Message

Vac. plate empty

Upper position

Table 3

Error messages of the applicator

Error treatment:

 Clear the error results

 Press the pause key to quit the error state.

Note!

In the case of errors check the Service Manual for adjustments and settings.

 After error correction, the print of the label causing the error cannot be repeated without re-start of the print job.

Except at the error " Vac. plate empty" . In this case, the latest label will print again after quit the error with the

pause key and then press the Enter button

 In the application mode "Apply/Print" send the signal "Print first label" or press the button

label to the tamp.

Possible Cause

Label has been removed from the waiting position at the pinch roller before the START

signal was initiated.

The label had not arrived the sensor area 5 sec. after it was printed or it was not

detected.

to send a printed