CAB MAESTRO 4S Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CAB MAESTRO 4S. CAB MAESTRO 4S 20 pagina's. Pcb separator
Pagina afdrukken9
Maintenance
Remove the existing roller blade
Shift the added fitted washer (cab part No.: 5903026.001) on the axle. Attach the roller blade FR4 (cab part No.:
8930509.001) like the descripion of the Operator's Manual..
Check the offset.
Setting of the lower stopper
1
2
3
Fig.20
Setting knob on the carriage
Turn the setting knob (3) clockwise up to the stopper.
Loosen screw (2).
Hold the lever (1) and turn the setting knob (3) with indicator clockwise for two increments.
Tighten screw (2).
Decouple the motor.
Pull the carriage via hand over the full cutting length.
The roller blade must not rotate.
If the roller blade rotate:
Repeat the setting with a little turn of the setting knob (3) to a small distance between the blades,
so that the roller blade is free over the full cutting length.
10
Errors
Cause of error
The food-switch is clear in the
moment of synchronization
The device is switched on and the
carriage with the upper blade will
moved by hand out of the start position
The carriage with the upper blade
is blocked in operation.
The food-switch will be clear if the
program is running.
Material is not separated after
program end
Table 5
Errors in operation and handling
Effect / Display
not ready
LED
step
Display
blink
distance
Display
cut
Display
length
not ready blink
LED
Error recovery
Switch of the device and switch it on again.
New synchronization
Press button home
Press the foot-switch and hold it
a Device will run into the start position
Clear the foot-switch
A new activation of the food-switch will continue
the program with a replay of the last cut.
Switch of the device and make a new
synchronization.
Chang programing
- More cuts
- Reduce the distance between upper
and lower blade in smaller steps
19