Cisco WS-X3011 Configuratie Opmerking - Pagina 20

Blader online of download pdf Configuratie Opmerking voor {categorie_naam} Cisco WS-X3011. Cisco WS-X3011 46 pagina's.

Pagina afdrukken

Access the Router Card Command-Line Interface

Many prompts in the System Conﬁguration Dialog include default answers, which are included in

square brackets following the displayed question. To accept a default answer, press Return;

otherwise, enter your response.

This section gives an example conﬁguration using the System Conﬁguration Dialog. When you are

conﬁguring your router card, respond as appropriate for your network.

At any time during the System Conﬁguration Dialog, you can request help by typing a question mark

(?) at a prompt.

Before you begin to conﬁgure the router card, obtain the correct addresses and the number of bits in

the subnet ﬁeld (if applicable) of the router ports from you system administrator.

Take the following steps to conﬁgure the router card using the System Conﬁguration Dialog:

Step 1

Step 2

Step 3

Step 4

20 Router Card (WS-X3011) Conﬁguration Note

When you are prompted to enter the initial dialog, enter yes or press Return to enter the

initial dialog mode:

Would you like to enter the initial dialog? [yes]: yes

When the System Conﬁguration Dialog asks whether you want to view the current

interface summary, press Return or enter yes:

First, would you like to see the current interface summary? [yes]:

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

IP-Address

Ethernet0

unassigned

BRI0

unassigned

Serial0

unassigned

Serial1

unassigned

Conﬁgure the global parameters. A typical conﬁguration follows:

Configuring global parameters:

Enter host name [Router]:

Next, you are prompted to enter an enable secret password. There are two types of

privileged-level passwords:

•

Enable secret password (a very secure, encrypted password)

•

Enable password (a less secure, nonencrypted password)

The enable password is used when the enable secret password does not exist.

For maximum security, be sure the passwords are different. If you enter the same

password for both, the router card will accept your entry, but will display a warning

message indicating that you should enter a different password.

Enter an enable secret password:

The enable secret is a one-way cryptographic secret used

instead of the enable password when it exists.

Enter enable secret: pail

The enable password is used when there is no enable secret

and when using older software and some boot images.

OK?

Method

Status

not set

down

not set

down

Protocol

down