Cisco WS-X3011 Configuratie Opmerking - Pagina 32

Blader online of download pdf Configuratie Opmerking voor {categorie_naam} Cisco WS-X3011. Cisco WS-X3011 46 pagina's.

Verifying Network Connectivity

After you have installed and conﬁgured the router, you can use the following commands in user

EXEC mode to verify network connectivity:

•

If there is a problem with network connectivity, refer to the section "Reading the LEDs" later in this

document. If there is still a problem, check the switch conﬁguration. Refer to the Catalyst 3X00

Installation and Conﬁguration Guide.

Getting More Information

For more information about router software conﬁguration, refer to the Cisco IOS conﬁguration

guide and command reference publications. These publications are available in the CD ROM that

accompanied your switch, or you can order printed copies. Refer to the section "Ordering

Documentation" at the end of this document.

Reading the LEDs

The LEDs indicate the current operating condition of the router card. You can observe the LEDs,

note any fault condition that the router card is encountering, and then contact your system

administrator or customer service, if necessary. For information about how to contact customer

service, refer to the section "Obtaining Service and Support."

Figure 12 shows the location of the LEDs on the router card. The LEDs are labeled and indicate

activity on a port by ﬂickering. When there is heavy activity on a port, the LED might be ON

constantly. If an LED is not ON when the port is active and the cable is connected correctly, there

might be a problem with the port.

Figure 12

FLE X SLO T

Cable, Pinout, and Port Speciﬁcations

This section contains the following information:

•

32 Router Card (WS-X3011) Conﬁguration Note

telnet—Logs in to a remote node

ping—Sends a special datagram to the destination device, then waits for a reply datagram from

that device

trace—Discovers the routes that packets take when traveling from one router to another

Router Card (WS-X3011) LEDs

BRI 0

ETH 0

SERIAL 0

SERIAL 1

DIAG

BRI 0

Synchronous Serial Cable Assemblies and Pinouts

ISDN BRI Port and Cable Pinouts

SERIAL 1

AUX

WS-X30 11