CabanaCoast CB-1224 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CabanaCoast CB-1224. CabanaCoast CB-1224 19 pagina's. Fire natural gas

C. Igniter Installation and Grounding

Your burner includes one of two styles of igniter box. These can be distinguished by the number of wire con-

nector prongs on the back side. If one prong is present, proceed to instructions for "Style A" . If two prongs ex-

ist, proceed to "Style B" . Note: Before installing ignition system, ensure that gas valves are closed and gas is

disconnected for safety.

Style A (One prong, self-grounding)

To properly install this igniter style, see diagram above.

Self-grounding igniters are designed to be installed

mounted to a metal surface such as an CabanaCoast®

control panel. If a control panel was not purchased with

your burner, an external grounding wire (SPK-GND on

page 17 of this user manual) can be purchased to relo-

cate the grounding contact point of this igniter to a

nearby metal surface.

Once properly grounded, located the black wire hang-

ing from your burner and insert it into the port on the

back side of the igniter.

Style B (two prongs, externally grounded)

This igniter relies on external grounding for proper op-

eration. A thin surface is required for mounting such as

an CabanaCoast® control panel. See above diagram

for mounting for proper installation.

A grounding wire is included with your igniter. To in-

stall, locate the black wire hanging from burner.

and plug it into either port on backside of igniter box.

Locate a nearby nut and bolt on bottom of burner and

loosen the nut enough to slide the forked end of

the included grounding wire underneath the nut as

shown above and retighten nut.

Plug the free end of grounding wire into the back of the

igniter box to complete installation.