Epson V11H179020 - PowerLite S3 SVGA LCD Projector Handleiding voor snelle installatie - Pagina 2
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Epson V11H179020 - PowerLite S3 SVGA LCD Projector. Epson V11H179020 - PowerLite S3 SVGA LCD Projector 7 pagina's. Supplemental / late breaking information
Ook voor Epson V11H179020 - PowerLite S3 SVGA LCD Projector: Specificaties (2 pagina's), Productinformatie (15 pagina's), Installatiehandleiding (19 pagina's), Specificaties (1 pagina's)
Pagina afdrukken
2
Connect your video source
The projector has 3 video connectors, as shown below. Each one requires a
different type of cable. A computer cable is included. You can purchase optional
video cables through Epson or at local electronics stores. You can connect up
to 3 video devices and use the remote control to switch among them.
1
Check the connectors on your video equipment. If more than one
connection is available, choose the one that provides the best quality.
(The projector connectors from highest to lowest quality are
Computer/Component Video, S-Video, and Composite Video.)
2
Make sure you have the right cable(s) for the connection(s) you want
to use, and the cables are long enough for your setup. If you need
a cable longer than the standard 6 to 10 feet, you may need a
distribution amplifier. (See the next page for accessory information.)
3
Before you connect your equipment, make sure everything is turned off.
4
Connect your video equipment to the projector.
Component
video to
VGA cable
NOTE
To play back audio through the projector, you can connect an audio
cable from your video device to the audio in ports on the projector.
See the User's Guide on your CD-ROM for instructions.
3
Set up the remote control
1
Remove the battery cover.
2
Insert the batteries.
3
Replace the battery cover.
The remote control is ready for use.
Computer
S-Video
cable
(included)
cable
RCA video cable
(composite
video)
Audio in ports