Cisco 2800 Series Configuratie - Pagina 3

Blader online of download pdf Configuratie voor {categorie_naam} Cisco 2800 Series. Cisco 2800 Series 10 pagina's. Cisco ios software configuration
Ook voor Cisco 2800 Series: Snelstarthandleiding (13 pagina's), Gegevensblad (8 pagina's), Snelstarthandleiding (47 pagina's), Toepassingsnotitie (41 pagina's), Snelstarthandleiding (45 pagina's), Overzicht (27 pagina's), Gegevensblad (5 pagina's), Gegevensblad (20 pagina's), configureren (32 pagina's)

Cisco 2800 Series Configuratie
You may see different startup messages:
If the
Note
ROM monitor, see theUsing

Verifying the Front Panel LED Indications

The front-panel indicator LEDs described in
useful during powerup. The built-in LED indicators in the front and rear panels are described in
on page
Overview of Cisco 2800 Series Routers
Table 1
Cisco 2800 Series LED Indicators
LED Label
LED Color or State
SYS
Solid green
PWR
Blinking green
Amber
Off
OL-5788-01
If you see the following messages, the router has booted with a configuration file and is ready for
initial configuration using Cisco Router and Security Device Manager (SDM).
yourname con0 is now available
Press RETURN to get started.
If the messages above do not appear, SDM and the
(SDM) Quick Start Guide
were not shipped with your router. If SDM is installed on your router, we
recommend using SDM to perform the initial configuration. To learn how to configure your router
using SDM, or how to obtain SDM and install it on your router, see the
Cisco Router and Security Device Manager" section on page
If you see the following messages, the router has booted and is ready for initial configuration using
the setup command facility or the command-line interface (CLI).
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To learn how to use the setup command facility to configure the router, see the
Using the Setup Command Facility" section on page
To learn how to use the CLI to configure the router, see the
CLI—Manual Configuration" section on page
prompt appears, your system has booted in ROM monitor mode. For information on the
rommon 1>
Using the ROM Monitor
9. For more detailed information about the LEDs, refer to the
System is operating normally
System is booting or is in ROM monitor mode
System error
Power is off or power fault
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
Cisco Router and Security Device Manager
5.
5.
"Initial Configuration Using the Cisco
8.
document.
Table 1
provide power, activity, and status information
online document.
Meaning
Configuring the Router
"Initial Configuration Using
"Initial Configuration
Table 6
"LED Indicators"
section of the
9