Cisco 7200 VXR Series Snelstarthandleiding - Pagina 16

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 7200 VXR Series. Cisco 7200 VXR Series 48 pagina's. Preparing for installation
Ook voor Cisco 7200 VXR Series: Gegevensblad (12 pagina's), Handmatig (14 pagina's)

Pagina afdrukken

Cisco 7200 VXR Series Snelstarthandleiding

NPE-G1 or NPE-G2 Optical Cable-Management Bracket

Step 1

Loosen the left and right captive installation screws.

Step 2

Hold the cable-management bracket so that it is positioned as shown in Figure 10.

Step 3

Place the left end of the cable-management bracket over the screw.

Step 4

Rotate the cable-management bracket down, until it slides behind the right captive installation screw.

Step 5

Tighten both captive installation screws.

Go to the "Two-Post or Four-Post Rack Installation" section on page 16.

Figure 11

Installing the 7200 VXR in a Two-Post and Four-Post Rack

Cisco 7200

Series

Two-post rack

Rack-mount bracket

10-32 x 3/8-inch slotted binderhead screws

Two-Post or Four-Post Rack Installation

Note

Inner clearance (the width between the inner sides of the two posts or rails) must be at least 17.00 inches (43.18 cm).

The height of the chassis is 5.25 inches (13.34 cm).

Step 1

Make sure that all chassis screws holding the network processing engine or network services engine, I/O controller, and

power supply are tightened and that any port adapter levers are in a locked position.

Step 2

Make sure the rack brakes are locked or the rack is stabilized.

Step 3

With the router front closest to you, lift it carefully into the rack. To prevent injury, avoid any sudden twists or moves.

Step 4

Slide the chassis into the rack, until the brackets meet the mounting strips or posts on both sides of the rack.

Step 5

Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the

rack or mounting strip.

Step 6

For each bracket, insert and tighten three 10-32 x 3/8-inch slotted binderhead screws, using the top, bottom, and one

other location on the bracket.

TOKEN RING

ETHERNET 10BT

ETHERNET-10BFL

FAST ETHERNET INPUT/OUTPUT CONTROLLER