Cisco AIR-SAP3702I-E-K9 Aan de slag handleiding - Pagina 12

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco AIR-SAP3702I-E-K9. Cisco AIR-SAP3702I-E-K9 45 pagina's.

• Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a

desktop.

You can mount the access point above a suspended ceiling but you must purchase

Note

additional mounting hardware: See

additional information.

• Access point power options: power supplied by the recommended external power supply (Cisco

AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub

(usually located in a wiring closet).

Access points mounted in a building's environmental airspace must be powered using PoE

Note

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installation Summary

Installing the access point involves these operations:

• Performing a pre-installation configuration (optional)

• Mounting the access point

• Grounding the access point

• Deploying the access point on the wireless network

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Performing a pre-installation configuration is an optional procedure. If your network

Note

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the

Network" section on page 15

"Mounting the Access Point" section on page 15

"Deploying the Access Point on the Wireless

for details.

for