ARGENTO PERFORMANCE Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARGENTO PERFORMANCE. ARGENTO PERFORMANCE 20 pagina's. Electric pedal-assisted cycle

Pagina afdrukken

7. MAINTENANCE INSTRUCTIONS AND ROADING

All maintenance operations must be carried out with the battery removed and

the bicycle resting on the stand.

After each routine maintenance operation, a check on the perfect functioning of all

the controls is mandatory.

This manual does not include information regarding disassembly and extraordinary

maintenance, as these operations must always be carried out exclusively by the

service staff of your authorized ARGENTO dealer.

The Assistance Service is able to provide all the information and to answer all

requests to take care of and keep your pedal-assisted bicycle perfectly efficient.

• If even a single check is negative, DO NOT RIDE the pedal-assisted bicycle.

• Immediately take all measures to carry out a suitable repair and if

necessary, contact the service center of your dealer.

7.1 Cleaning

Cleaning the pedal-assisted bicycle is not only a matter of decorum but also allows

you to immediately detect any defect in the same.

In order not to damage or compromise the operation of the various components,

especially the electrical parts, cleaning must be carried out taking certain

precautions. It is absolutely forbidden to direct pressurized water jets towards the

electrical parts, the motor, the display and the battery, for which cleaning with a

sponge is recommended.

Before starting the pedal-assisted bicycle, dry completely with low-pressure

compressed air and check that there is no residual moisture on the electrical

components.

7.2 Chain lubrication

It is important to lubricate the chain regularly, to avoid excessive wear and to extend

its life.

Clean the entire length of the links with a rag.

Spray a specific grease in spray on the transmission chains on all the links.

7.3 Checking the parts

The supporting frame of the pedal-assisted bicycle and the welds must be free of

visible defects such as: cracks, deformations, incisions, corrosions, etc.

Make sure that all the bolts and pedals of the pedal-assisted bicycle are

properly tightened.

Check the condition and fastening of the battery, the sheaths of the electric cables

must be in good condition and the terminals must be tight and not corroded.

Check the battery charge status by means of the indicator on the handlebar display.

For a correct use of the battery of your EPAC vehicle it is suggested to

always charge the battery after each use of the bike.

Using the specific inflation valve on the rims, check the tire inflation pressure using

a compressor and a gun with pressure gauge.

Check the condition of the tread, the rim and the fastening of the rims to the hubs.

In case of tire replacement, contact the After-Sales Service or a qualified tire dealer.

Negative verification