Epson 3880 - Stylus Pro Color Inkjet Printer Netwerkhandleiding - Pagina 16

Blader online of download pdf Netwerkhandleiding voor {categorie_naam} Epson 3880 - Stylus Pro Color Inkjet Printer. Epson 3880 - Stylus Pro Color Inkjet Printer 38 pagina's. Printer
Ook voor Epson 3880 - Stylus Pro Color Inkjet Printer: Brochure (3 pagina's), Specificaties (2 pagina's), Netwerkhandleiding (39 pagina's), Brochure & specificaties (8 pagina's), Start Here (2 pagina's), Start hier Handleiding (6 pagina's), Beperkte garantie (12 pagina's), Handleiding kleurbeheer (47 pagina's), Brochure & specificaties (8 pagina's), Snelstarthandleiding (2 pagina's)

Setting Up the Network Interface

Follow the instructions below to connect the network interface to the network.

1. Make sure that your printer is turned off.

2. Connect one end of the network cable to the RJ-45 connector on the

network interface, and the other end to the network.

Caution:

❏ You must use a Category 5 or higher shielded twisted-pair cable to

connect the network interface to prevent malfunction.

❏ Do not connect or disconnect the network cable when the printer is on.

Note:

You can use both 10Base-T and 100Base-TX. When you print a lot of data, we

recommend using the highest speed available for your product with light network

traffic.

3. Turn on your printer.

Note for Mac OS X:

Since the printer supports Bonjour and is on by default, you can use the printer on

a network just by connecting it to the network. If you want to disable the Bonjour

setting, use the printer's control panel. See "Configuring the Network Interface"

on page 16 for details.

Now you can configure the network interface to use TCP/IP on the network

and print a network status sheet.

After connecting the printer to the network, you need to configure the network

interface for use on a TCP/IP network. The following items are used to make

network settings on the printer's control panel (available only when

NETWORK SETUP is set to ENABLE):

Item

NETWORK SETUP

Setting Up Your System for Network Printing

Parameter

DISABLE, ENABLE