Cisco Catalyst 9136I Series Aan de slag handleiding - Pagina 10
Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco Catalyst 9136I Series. Cisco Catalyst 9136I Series 32 pagina's.
Pagina afdrukken
Cisco Catalyst 9136I Series Access Points
6
Preparing the AP for Installation
Before you mount and deploy your access point, we recommend that you perform a site survey (or use the site planning
tool) to determine the best location to install your access point.
You should have the following information about your wireless network available:
Access point locations.
Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a desk top.
You can mount the access point above a suspended ceiling but you must purchase additional mounting
Note
hardware: See
Access point power options: Use Cisco power injector-Cisco Power Injector AIR-PWRINJ7= or UL approved Listed
Power Adapter-802.3at (PoE+) 802.3af, or Cisco Universal PoE (Cisco UPOE).
Use an UL listed power adapter with rated output 42.5-57 Vdc, min. 1.11A, Tma is 50 degree C minimum,
Note
Altitude is 3048m minimum.
Note
The
UL approved Listed Power Adapter must meet the following minimum specifications: Rated output of
42.5-57 Vdc, min. 1.11A, Tma is 50°C minimum, Altitude is 3048m minimum.
If 802.3af is used, both the 2.4 GHz and 5 GHz radios will be reduced to 1x1 and Ethernet will be
Note
downgraded to 1 GbE. The USB port will also be off.
Operating temperature:
-
C9136I: 32°-122°F (0°-50°C)
When installing the C9136I in an environment where the ambient temperature is in the range of
Note
104
°-
radios and the uplink Ethernet will downgrade to 1GbE. However, the USB port will remain enabled.
Cisco recommends that you make a site map showing access point locations so that you can record the device MAC
addresses from each location and return them to the person who is planning or managing your wireless network.
7
Installation Overview
Installing the access point involves these operations:
Step 1
Preparing the AP for Installation, page 10
Step 2
Step 3
Mounting the Access Point, page 13
Powering the Access Point, page 15
Step 4
"Mounting the Access Point" section on page 13
122
F (>40
50
C), the access point configuration will change from 8x8 to 4x4 on the 5 GHz
°
°-
°
for additional information.
(optional)
10