Cisco Linksys WAP610N Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco Linksys WAP610N. Cisco Linksys WAP610N 41 pagina's. Wireless-n access point with dual-band
Ook voor Cisco Linksys WAP610N: Snelle installatiehandleiding (8 pagina's)
Pagina afdrukken
Chapter 3
b. Within two minutes, click the Wi-Fi Protected
Setup button on the Access Point's Wi-Fi Protected
Setup screen.
c. After the client device has been configured, click
OK. Then refer back to your client device or its
documentation for further instructions
Congratulations
The Wi-Fi Protected Setup Status, Wireless Band,
Network Name (SSID), and Security method are
displayed at the bottom of the screen.
2. Enter Wi-Fi Protected Setup PIN from Client
device
Use this method if your client device has a Wi-Fi
Protected Setup PIN number.
a. Enter the PIN number in the field on this screen.
b. Click Register.
c. After the client device has been configured, click
OK. Then refer back to your client device or its
documentation for further instructions
Congratulations
The Wi-Fi Protected Setup Status, Wireless Band,
Network Name (SSID), and Security method are
displayed at the bottom of the screen.
3. Enter Wi-Fi Protected Setup PIN from Access Point
on Client device
Use this method if your client device
requests the Access Point's PIN number.
a. On the client's Wi-Fi Protected Setup screen, enter
the PIN number listed on the Access Point's Wi-Fi
Protected Setup screen. Then click Register or the
appropriate button. (The PIN number is also listed
on the label on the bottom of the Access Point.)
b. After the client device has been configured, click
OK. Then refer back to your client device or its
documentation for further instructions
Wireless-N Access Point with Dual-Band
Advanced Configuration
Congratulations
The Wi-Fi Protected Setup Status, Wireless Band,
Network Name (SSID), and Security method are
displayed at the bottom of the screen.
Wireless > Wireless MAC Filter
Wireless access can be filtered by specifying the MAC
addresses of wireless devices within range of your network.
Wireless > Wireless MAC Filter
Wireless MAC Filter
Enabled/Disabled
To filter wireless users by MAC
Address, either permitting or blocking access, select
Enabled. If you do not wish to filter users by MAC Address,
keep the default setting, Disabled.
Access Restriction
Prevent
Select this to block wireless access by MAC
Address. This option is selected by default.
Permit
Select this to allow wireless access by MAC
Address. This option is not selected by default.
MAC Address Filter List
Wireless Client List
Click this to open the Wireless Client
List screen.
7