Epson C11CA30201 - Artisan 700 Photo All-in-One Printer Functiehandboek - Pagina 23

Blader online of download pdf Functiehandboek voor {categorie_naam} Epson C11CA30201 - Artisan 700 Photo All-in-One Printer. Epson C11CA30201 - Artisan 700 Photo All-in-One Printer 28 pagina's. Using the control panel for wireless network installation
Ook voor Epson C11CA30201 - Artisan 700 Photo All-in-One Printer: Handleiding voor netwerkinstallatie (41 pagina's), Belangrijke installatie-informatie (3 pagina's), Specificaties (2 pagina's), Snelstarthandleiding (8 pagina's), Product ondersteunings bulletin (5 pagina's)

The printer does not appear in the Add Printer window (Mac OS X)

Make sure the printer driver was installed correctly and that your computer's

TCP/IP settings are configured correctly.

Printing Problems

Cannot print over the network

■

Print a Network Status Sheet (see page 25) and verify that the network

settings are correct.

■

When using TCP/IP, make sure the printer's IP address is set correctly for your

network. If your network does not assign IP addresses using DHCP, you will

need to set the IP address manually.

■

Print a Network Status Sheet (see page 25). If the Link Status says Disconnect,

make sure that the wireless router or access point is turned on and that the

settings are correct for your wireless network.

■

Reset the printer's network settings (see page 26) and perform a first-time

installation of the printer and software (see page 3).

Printing is slow or the print is cut off

Print a Network Status Sheet (see page 25) and check the Signal Condition. If it's

poor, try moving the printer closer to your wireless router or access point. Avoid

placing the printer next to a microwave oven, 2.4 GHz cordless phone, or large

metal object such as a filing cabinet.

A dial-up connection dialog box appears when printing with EpsonNet

If you use a dial-up connection for Internet access, you will see this message every

time you print. Try connecting to the Internet using a LAN connection or set your

dial-up connection to dial manually (Never dial a connection).

Troubleshooting