ACU-RITE 02064C Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ACU-RITE 02064C. ACU-RITE 02064C 13 pagina's. Professional weather center

Pagina afdrukken

Troubleshooting

Problem

• Relocate the display unit and/or the 5-in-1 sensor.

The units must be within 330 ft (100 m) of each other.

• Make sure both units are placed at least 3 feet

(90 cm) away from electronics that may interfere with

the wireless communication (such as TVs, microwaves,

computers, etc).

• Use standard alkaline batteries (or lithium batteries in

sensor when temperature is below -4ºF/-20ºC). Do not

No outdoor sensor

use heavy duty or rechargeable batteries. NOTE: It

reception

may take up to 20 minutes for display unit and sensor

to synchronize after batteries are replaced.

no bars

• Synchronize the units:

1. Bring both the sensor and display unit indoors and

remove power adapter/batteries from each.

2. Reinstall batteries in outdoor sensor.

3. Reinstall power adapter/batteries in display unit.

4. Let the units sit within a couple feet of each other

for about 20 minutes to gain a strong connection.

Flashing of the outdoor temperature may be an

indication of wireless interference.

Outdoor

• Make sure the A-B-C switch in the battery

temperature

compartments of both the display unit and sensor are

is flashing or

switched to the same letter. You may choose A, B or

showing dashes

C; but both units must match to sync up. Sometimes

changing to a different channel can help.

• Weather Forecast icon predicts conditions for the next

12 to 24 hours, not current conditions.

• Has Learning Mode icon disappeared from the

display unit? Learning Mode must complete before

forecast and pressure will be accurate.

Inaccurate forecast

• Allow unit to run continuously for 33 days. Battery

removal or resetting the display unit will restart

Learning Mode. After 14 days, forecast should be

fairly accurate, however Learning Mode calibrates for

a total of 33 days.

Possible Solution

Troubleshooting

Problem

• Make sure both the display unit and 5-in-1 sensor are

placed away from any heat sources or vents

(see page 11).

Inaccurate

• Make sure both units are positioned away from

moisture sources (see page 11).

temperature or

humidity

• Make sure 5-in-1 sensor is mounted at least 5 ft off of

the ground.

• Calibrate indoor and outdoor temperature and

humidity (see page 19).

• Check to ensure the rain gauge stabilizer (plastic tab)

has been removed from the bottom of the sensor (see

page 7).

No rainfall

• Clear debris, such as leaves, out of the rain collector

funnel and debris screen.

• Calibrate the Rain Gauge (see page 20).

• What is wind reading being compared to? Pro

weather stations are typically mounted at 30 ft high

or more. Make sure to compare data using a sensor

positioned at the same mounting height.

Inaccurate wind

• Check location of the sensor. Ensure it's mounted a

minimum of 5 ft in the air with no obstructions around

readings

it (within several feet).

• Ensure wind cups are spinning freely. If they hesitate

or stop try lubricating with graphite powder or spray

lubricant.

• Check that the batteries are installed correctly.

Batteries may need to be replaced.

Display screen

• Reset the display by pressing and holding the CLEAR

not working

RECORD / RESET button, located in the battery

compartment of the display unit. Date and time will

need to be entered after a reset.

Possible Solution