Argo ADIBS13DC Handleiding voor installatie-instructies - Pagina 15

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Argo ADIBS13DC. Argo ADIBS13DC 19 pagina's. Split air conditioner system
Ook voor Argo ADIBS13DC: Gebruiksaanwijzing (15 pagina's), Gebruiksaanwijzing (17 pagina's)

Pagina afdrukken

(3) AUTOMATIC ADDRESSING PROCEDURE

System requirements:

Outdoor unit must have a recent firmware version that supports the automatic addressing procedure.

Indoor units must have a recent firmware version that supports the automatic addressing procedure

Dip-switch for communication address setting on the indoor unit (SW2) must be left to the factory default state, i.e. to

the OFF position.

Activation of automatic addressing procedure

Power on the whole system.

Verify that there is no error on the indoor units, but the error "Address not set" (see Auto-diagnosis table).

Switch on the remote controller of any of the indoor units of the system and set it as follows:

Press together FAN + IFEEL buttons for more than 7 seconds and release them pointing the remote controller to the

indoor unit receiver. Be sure to send the signal to only one indoor unit and that there is no other indoor unit that could

receive the same signal.

If the signal is received, the indoor unit will emit 5 consecutive beeps.

After some seconds, every indoor unit will show the following LED combination to confirm that the automatic addressing

procedure has been activated.

From this moment until the end of the procedure the indoor units will not receive

anymore the signals from the remote controllers (infrared receiver is disabled).

Execution of automatic addressing procedure

Once the procedure has been activated, the system will run automatically to set

the address of every indoor unit. In this period, compressor and fan motor will be

activated.

Once activated, the procedure takes about 4-5 minutes per outdoor unit circuit to

be completed. This time doesn't depend on the number of indoor units actually

connected to the outdoor unit, but on the number of refrigerant circuits of the outdoor

unit.

End of automatic addressing procedure

When all the circuits have been tested and the address of every indoor unit has been set, the outdoor unit will stop and

every indoor unit will switch off (standby mode).

In any case (procedure successful or failed) the infrared receiver of every indoor unit will be re-activated.

If there is no error on the indoor units, the system is ready to be used.

If there is the error "Address not set" (see Auto-diagnosis table) on any indoor unit, re-run the automatic addressing

procedure or manually set the address on that indoor unit with the dip-switch or with the remote controller.

BUTTON

working mode (COOL - HEAT)

set point

fl ap

fi lter

night mode / high mode

ifeel

Fan

OPERATION

GREEN

SETTING

AUTO

24°C

AUTO

OFF

Any

STANDBY

TIMER

RED

BLUE