ACU-RITE 1035 Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ACU-RITE 1035. ACU-RITE 1035 14 pagina's. Professional weather center
Ook voor ACU-RITE 1035: Gebruiksaanwijzing (17 pagina's)

Pagina afdrukken

Care & Maintenance

Display Unit Care

Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives. Keep

away from dust, dirt and moisture. Clean ventilation ports regularly with a

gentle puff of air.

5-in-1 Sensor Care

Clean The Sensor

Clean with a soft damp cloth. Do not use caustic cleaners or abrasives that will

mar the polished surfaces of the rain collection funnel or the solar cell.

Scratches will result in decreased performance and reliability.

Insect Prevention

Insects may cause obstructions and interrupt data by nesting in or on the 5-in-1

sensor. To limit this problem, spray sensor with a household insect repellent.

Consult the insect repellent instructions prior to use.

Snow & Freezing Weather

The 5-in-1 sensor will not be damaged by freezing conditions. NOTE: If the rain

collector cup fills with snow and then melts, it will register as rain on the

display unit.

Clean The Rain Collector Cup

Remove and empty rain collector debris filter. The debris filter is located in the

rain collector funnel. Remove from the top by gently squeezing and pulling out.

Clean the Wind Vane & Anemometer

Remove foreign matter from the outside of the sensor for free movement of the

wind vane and anemometer. If needed, use a small amount of spray lubricant,

clear silicone or graphite powder on the anemometer for improved movement.

Calibration

Calibrate Temperature & Humidity

The indoor / outdoor temperature and humidity readings can be calibrated on

the display unit to improve accuracy. Calibration improves accuracy when

5-in-1 sensor placement or environmental factors impact your data accuracy.

1. Choose the weather category you wish to calibrate by pressing the "▲" or

"▼" buttons until the category is displayed on the Selectable Category part

of the display unit.

SETUP

5-in-1 Sensor Setup

1. Install or Replace Batteries

Batteries MUST be installed for this

product to operate. AcuRite

recommends high quality alkaline or

lithium batteries for the best product

performance. Heavy duty or

rechargeable batteries are not

recommended.

The 5-in-1 sensor requires lithium

batteries in low temperature

conditions. Cold temperatures can

cause alkaline batteries to function

improperly. Use lithium batteries in the

5-in-1 sensor for temperatures below

-4ºF / -20ºC.

1. Slide off the battery compartment

cover.

2. Insert 4 x AA batteries into the

battery compartment, as shown.

A B C

A-B-C Switch

set to match

display unit

Install Batteries

4 AA batteries

Follow the polarity (+/-) diagram in

the battery compartment.

3. Replace the battery cover.

2. Remove Rain Gauge Stabilizer

Locate and remove the rain gauge

stabilizer (plastic tab) taped into the

bottom of the sensor. The rain gauge

will not function until this is removed.

3. Set the A-B-C Switch

Locate the A-B-C switch inside the

battery compartment. Set the A-B-C

switch to A, B or C. You must select

the same letter choices for both the

sensor and the display unit in order

for the units to synchronize.

Rain Gauge Stabilizer

Remove and discard