Epson ET-16650 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Epson ET-16650. Epson ET-16650 4 pagina's.

Pagina afdrukken

Wait for the ink to fill the tank. Do not squeeze the bottle.

Note:

If ink does not flow from the bottle, lift and reinsert the

bottle.

When the ink bottle is empty, remove the ink

bottle and replace the bottle cap.

Note:

Do not leave the ink bottle inserted;

otherwise the bottle may be damaged or ink

may leak.

Close the black ink tank cap.

Repeat the previous steps for the other colors.

Close the ink tank cover.

Connect the power cord to the back of the product and to

an electrical outlet.

Caution:

Do not connect to your computer yet.

Press the

power button to turn on the product.

Note:

If an error message appears, turn off the product and

check that no protective material has been left inside the product

and that the transportation lock is in the printing position.

Select your language, country, date, and time.

Note:

You can change these settings later using the product's

control panel. For more information, see the online User's Guide.

Follow steps 12 and 13 to continue ink charging.

When the message to see the Start Here sheet appears

on the LCD screen, press and hold OK for 5 seconds.

When the ink confirmation message appears on the LCD

screen, select Done to start charging the ink. Ink charging

takes approximately 9 minutes. A message appears when

ink charging is complete. Press OK to proceed with initial

setup.

Note:

Part of the ink from the included bottles is used for printer

setup. You will notice ink levels in the tanks decrease during

charging. This decrease is normal and does not affect the stated

in-box yields.

Caution:

Do not unplug or turn off the product, raise the

scanner unit, or load paper while the product is charging or you'll

waste ink.

Load paper

See the online User's Guide for information about loading

capacity, available paper types and sizes, loading envelopes,

and using the rear paper feed slot or ADF.

Make sure the

product is not

charging ink, then

pull out the paper

cassette.

Slide the side edge guides

all the way out.