CabKing 6V3 Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} CabKing 6V3. CabKing 6V3 20 pagina's.

5. Place the clear stone trays on top of the right and left hoods. The stone trays are used to

hold your stones and work pieces. Insert the hand rests into the drip pans and slide the

splash guards on to both sides of the drip pans. Adjust the position of the splash guards

according to the splash.

6. Optionally, attach the side panels to the hoods (FIG. B).

magnetically attached to the hood for easy removal. Twist the black side

spray tubing upwards to easily attach and remove the panels. The side

panels control the water splash, however not installing them provides

easier access to the diamond lap and polishing pad.

The CabKing-6V3 water system is single-pass, meaning not re-circulating. DO NOT SET-UP THE

WATER SYSTEM AS A RE-CIRCULATING SYSTEM. Read further about the CabKing water

system on page 16 after set-up.

7. Connect the water drainage system by attaching the clear drip pan

tubing to the rear spout of the drip pans (FIG. C). Secure the connection

by positioning the spring clasp so it covers the spouts. Tug on the tubes

slightly to make sure they are secured.

8. Place the unconnected ends of the clear drip pan tubes in a large, 5

gallon empty bucket (not included) (FIG. D), drain hole, or wherever you

would like the dirty water from the pans to drain out. It is important that

you have the drip pan tubes pointing downward from the machine. This

will allow gravity to drain the water from the drip pans. If you notice the

pans filling up with water, most likely the drain tubes are not sufficiently

angled downward. You can tilt the drip pans up and shake the tubing to

drain. Once you have this properly set-up you may want to cut the tubing

so there is no excess slack. This will further help to drain the pans.

9. MAKE SURE WATER PUMP IS NOT CONNECTED TO POWER SUPPLY.

Remove the protective backing from the T-junction (found behind the

motor) and place the sticky, adhesive side to the baseboard behind the

motor, on either side of the lamp (FIG. E). Connect the water intake

system by inserting the clear tube from the T-Junction into the water

pump (FIG. F). Slightly tug on the tubes to make sure they are secured.

Place the water pump in a separate, large 5 gallon bucket (not included)

filled fully with clean water. The length from the bucket to the unit

should not be more than 6 feet.

SETTING UP THE WATER SYSTEM

They are

FIG. B

FIG. C

FIG. D

FIG. E

FIG. F