Argo Argoclima Magico Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo Argoclima Magico. Argo Argoclima Magico 10 pagina's. Movable air conditioner

OPERATION

COOLING
Place the air conditioner as near as possible to the window. Fit the flexible tube by
G
hooking it to the rear of the unit. Extend the flexible tube just enough to reach the
outdoor, passing under the window shutters set ajar.
In case there is a window sill towards the inside of the room, it might be better to
G
use the supplied outlet nozzle. Insert the nozzle into the free end of the flexible
tube.
Open the window and lock one of the shutters. Place the outlet nozzle between the
G
two shutters, held together with the supplied lace.
EG
Avoid sharp bends or plies of the flexible tube.
G
In case of porthole utilise make a 140 mm diameter hole in the window pane.
G
DEHUMIDIFICATION (DRY)
When the air conditioner is in the dehumidification mode, it doesn't cool the room.
When you use the air conditioner in the dehumidification mode, you don't have to
use the flexible tube. For maximum dehumidification efficiency leave the rear
discharge outlet free to discharge directly into the room.
Remove the flexible tube by grasping it at the attachment point on the air
G
conditioner and twisting it until you release it from the blocking hooks.

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES

Remove the lid in the rear part of the remote control unit.
G
Insert two AAA alkaline batteries of 1,5 V-DC.
G
Make sure the batteries point in the direction marked in the
battery compartment.
The batteries last about six months. Depending on how
G
much you use the remote control unit.
Remove the batteries if you do not use the remote control
unit for more than one month.
Press the +, -, SET and CLEAR buttons together after
batteries replacement.
(This operation allows you to reset correctly all the
programs. The remote control unit is to be set up again).
Replace the batteries when the remote control unit lamp
fails to light, or when the air conditioner does not receive
the remote control unit signals.
The batteries of the remote control contain polluted
G
substances exhausted batteries must be disposed
according to the laws in force.

TEMPERATURE SENSOR SELECTOR

Under normal conditions the room temperature is detected
G
and checked by the temperature sensor placed in the
air conditioner.
Press the remote control I FEEL button to activate the tem-
G
perature sensor placed in the remote control. This function is
designed to provide a personalised environment by transmit-
ting the temperature control command from the location next
to you. Therefore, in using this function, the remote control
should always be aimed, without obstruction, at the
air conditioner.
4
NO!
NOTE
The remote control unit sends
the temperature signal to the air
conditioner regularly at two
minute intervals. If the signal
from the remote control unit
stops for more than five
minutes due to some troubles,
the air conditioner will switch
to the temperature sensor
which is built into the unit and controls the room tempera-
ture. In these cases, the temperature around the remote
control
unit
may
differ
detected in the air conditioner position.

OPERATION WITH THE REMOTE CONTROL UNIT

When using the remote control unit, always point the unit trans-
mitter head directly at the air conditioner receiver.
RECEIVER
TRANSMITTER HEAD
REMOTE CONTROL UNIT
VISORE TELECOMANDO
from
the
temperature