Cisco Catalyst 3000 Handleiding voor naleving van regelgeving en veiligheidsinformatie - Pagina 27

Blader online of download pdf Handleiding voor naleving van regelgeving en veiligheidsinformatie voor {categorie_naam} Cisco Catalyst 3000. Cisco Catalyst 3000 32 pagina's. Catalyst blade switch 3000 series for dell

Pagina afdrukken
EMC Environmental Conditions for Products Installed in the

European Union

This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect
to EMC:
•
•
•
In addition, if equipment is operated in a domestic environment, interference may occur.

EMC Class A Notices and Warnings

This section includes the EMC Class A warnings for the Cisco Catalyst Blade Switch 3000 Series for
Dell:
•
•
•
•
•
•
•

Class A Notice for FCC

Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users will be
required to correct the interference at their own expense.

Class A Notice for Canada

This Class A digital apparatus complies with Canadian ICES-003.
78-17053-02
A separate defined location under user's control.
Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
AC power distribution shall be one of the following types, where applicable: TN-S and TN-C as
defined in IEC 364-3.
Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3000 Series for Dell
EMC Environmental Conditions for Products Installed in the European Union
27