Cisco SX80 Installatiehandleiding - Pagina 3

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco SX80. Cisco SX80 7 pagina's. With touchpad 10
Ook voor Cisco SX80: Snelle referentiehandleiding (2 pagina's), Handmatig (45 pagina's), Handmatig (45 pagina's), Gebruikershandleiding (19 pagina's), Installatiehandleiding (24 pagina's), Installatiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's), Installatiehandleiding (7 pagina's), Referentiehandleiding (8 pagina's), Aan de slag handleiding (46 pagina's)

Pagina afdrukken

Installation guide for Cisco TelePresence SX80

Connect to LAN, microphones, loudspeakers, Touch 10, cameras and displays

Make sure all units are switched off when connecting or disconnecting cables.

LAN (RJ-45)

Always use the

Ethernet port

for LAN.

4 × programmable

GPIO pins

(Euroblock,

2 × USB

SWITCH

PoE

injector

Touch 10 control panel (RJ-45)

Insert the provided PoE injector

between Touch 10 and the codec's

or 3

Ethernet port

The audio line outputs may be configured to be used for loudspeakers.

The Ethernet connector is behind the lid at the rear of Touch 10. The Ethernet cable between

Touch 10 and the PoE injector must be PoE rated (provided). The Ethernet cable between the PoE

injector and the codec is not required to be PoE rated (not provided).

Microphones, max 8 (Euroblock, 3.5 mm)

If your microphone cable has 3 pins,

use ,

mute pin ( ) unused.

3.5 mm)

10 Gb Ethernet

Power

(100-240 VAC,

To camera control

50/60 Hz)

Cameras, max 3 (HDMI)

How to connect cameras are described

overleaf. Note that different cameras use

different ports for camera control.

and ground ( ) and leave the

2 × stereo audio line in,

e.g. from PC

(Euroblock, 3.5 mm)

Video input,

Analog video input:

e.g. from PC

Composite, Y;

(DVI-I)

S-video, Y and C

(BNC)

There is no DC power output from the camera control port. Use an external power supply for the

camera.

The codec's 2

and 3

Cisco's SpeakerTrack 60 and Precision 60 cameras (see details for the cameras overleaf).

Connect a network switch to the codec's 2

to support your devices.

Loudspeakers, mono or stereo (Euroblock, 3.5 mm)

Use speakers with amplifiers. The speaker/amplifier

should have balanced input to avoid ground loop noise.

2 × stereo audio line out,

e.g. to recorder

(Euroblock, 3.5 mm)

Camera control

for the PrecisionHD

1080p 4xS2 camera

Displays, max 3

(2 HDMI, 1 DVI-I)

Ethernet ports should be used for the Touch 10 control panel, as well as for

or 3

Ethernet port, if you need more than two ports

Serial port

Ground

(D-SUB 9)

(Protective earth)

Power

(D-SUB 9)