Cisco TelePresence IX5000 Eerste installatie - Pagina 2
Blader online of download pdf Eerste installatie voor {categorie_naam} Cisco TelePresence IX5000. Cisco TelePresence IX5000 40 pagina's. Field-replaceable units and countryand region-specific power connectors
Ook voor Cisco TelePresence IX5000: Gebruikershandleiding Snel aan de slag (15 pagina's), Gebruikershandleiding (26 pagina's), Installatiehandleiding (36 pagina's), Handmatig (44 pagina's)
Pagina afdrukken
Summary of Changes
Summary of Changes
The following table shows you the changes that have been made to this document.
Date
April 17, 2017
July 1, 2016
April 7, 2016
April 24, 2015
Immediate Software Upgrade Requirements
Your IX system comes preloaded with a downlevel version of IX software. You must upgrade your
system to the latest version on Cisco.com before you use your system to place and receive calls.
Due to some issues with the preloaded software, make the following changes to your system before
you load the software (requires signing in to Unified CM and the IX system administration GUI):
•
•
Cisco TelePresence IX5000 and IX5200 First-Time Setup
2
Summary of Change
Added the
•
Added step
•
camera alignment on two-table systems.
Added
•
reboot the IX system if an auxiliary display is added.
Changed the terminology of Touch 10 device to "Touch 10 controller".
•
Step 4c. of the procedure in the
•
page 15
displays.
Updated the
•
to include the path to the Download Software page.
If the camera alignment fails with a Walnut table installation, more steps may
•
be required.
been updated to include this information.
If you configure a static IP address for your system, and a domain name is also
•
required, either use the set network IP static CLI command, or configure
your system in Mixed mode. The
With a Static Network Address" section on page 10
include this information.
The "Configuring an Alternate TFTP Server (Optional)" section has been
•
removed, as that information is covered in
Unified Communications Manager for Your Cisco TelePresence System"
section on page
The title of the
•
Procedure" section on page 3
content. The previous title was "Preventing Touch 10 Configuration Issues".
Make sure that your system is not configured for secure mode in Unified CM. After you perform the
upgrade, and after your system is registered to Unified CM, change the system settings in Unified
CM if secure mode is required.
Make sure that a Certificate Trust List (CTL) is not present on your system and, if present, delete it.
To check, after initial system boot, log in to the IX System administration GUI (default
–
username and password is admin / cisco).
"Requirements for Auxiliary Displays" section on page
5d.
on page 19 in the
Step 19
on page 36 in the
"Performing First-Time Setup" section on
was updated to add information on correct cabling for auxiliary
"Immediate Software Upgrade Requirements" section on page 2
Step 5
of
"Performing First-Time Setup" section on page 15
"Configuring an IX5000 or IX5200 System
5.
"Required First Time Power-On and Software Installation
has been changed to correctly reflect its
"Performing First-Time Setup"
"Performing First-Time Setup"
has been updated to
Step 4
in the
"Configuring Cisco
11.
to perform
section to
has
OL-27038-01