Cisco TelePresence MX200G2 Handmatig - Pagina 12

Blader online of download pdf Handmatig voor {categorie_naam} Cisco TelePresence MX200G2. Cisco TelePresence MX200G2 45 pagina's. In-room control on touch 10
Ook voor Cisco TelePresence MX200G2: Handmatig (45 pagina's)

Pagina afdrukken

Apply In-room Control panel to the video system

Table of contents

(Not available when using the offline editor. Instead, you should

export the in-room control panel to a file in order to save your work

for later.)

Introduction

Apply the in-room control panel to the video system. You will see the

results immediately on the Touch 10.

Create a user interface

• Choose

API for in-room control

Check the result on Touch 10

(Not available when using the offline editor.)

Widgets

Tap the in-room control icon in the Touch 10 status bar to open the

in-room control panel.

Command reference

Troubleshooting

Tips and tricks

Examples

In-Room Control on Touch 10

for Cisco TelePresence

Example of two sets of in-room control panels. The Global has been

MX200 G2, MX300 G2,

selected (blue light bulb) and a panel consisting of three panes is shown.

MX700, MX800,

To the right of the Share button, a in-room control Homescreen entry icon

SX10, SX20, SX80

has been added.

Collaboration Endpoint

software version CE8.2

D15358.02 - JULY 2016

Which in-room control icons (entry icons) used is defined by the

Panel icon

www.cisco.com

Export > To codec

setting, as shown on the previous page.

Export the In-room Control panel to file

You may also export the in-room control panel to a file. This file can

be imported back into the editor at a later stage. Note that you will

export all your work (Global, Homescreen and In-Call panels)

• Choose

Export > To file

If you are using the offline editor, this is the only way you can save

your work for later.

Exporting to file may also be useful as a way of creating a design

template if you are going to push the same in-room control panel to

multiple video systems.

Files exported while connected to a video system are in the same

format as files exported from an offline editor. This means that any

of these files can be imported into an editor launched from a video

system's web interface, and then pushed to the video system's

Touch 10.

Remove a panel from Touch 10

To remove a panel from the Touch 10, remove it from the editor and

then push your editor configuration to the video system. The panel's

icon should disappear instantly.