Sony CCU-790P Bedieningshandleiding - Pagina 15

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Sony CCU-790P. Sony CCU-790P 18 pagina's. Camera control unit
Ook voor Sony CCU-790P: Brochure & specificaties (14 pagina's)

Pagina afdrukken
Sony CCU-790P Bedieningshandleiding

ROM version indication

Exiting the Self-diagnostic mode

Press the CHARACTER button on the RCP-750/751/920/
921 remote control panel or the RM-B750 repeatedly to
display the ROM version indication page, then press the
CHARACTER button again.

When an error occurs

The error message is displayed on the monitor. In such a
case, the self-diagnostics page corresponding to the board
where the error has occurred appears by pressing the
CHARACTER button.
When you keep pressing the CHARACTER button, pages
are automatically turned to a screen with no characters
(character OFF screen).

Specifications

General

Power requirements
CCU-790: 120 V AC, 50/60 Hz
CCU-790P: 100 V/120 V/220 to
240 V AC selectable, 50/60 Hz
(factory setting: 220 V to 240 V AC)
Power consumption
CCU-790: 3.5 A max. for entire system
CCU-790P: 4.2 A max. for entire
system
Peak inrush current
(1) Power ON, current probe method:
90 A (240 V)
(2) Hot switching inrush current,
measured in accordance with
European standard EN55103-1:
20 A (230 V)
1)
50 to 1,000 m (Fujikura φ8.5 mm)
Cable length
75 to 1,500 m (BELDEN 9232
φ13.2 mm)
100 to 2,000 m (Fujikura φ14.5 mm)
Operating temperature
+5 °C to +40 °C (41 °F to 104 °F)
Storage temperature
–20 °C to +50 °C (–4 °F to +122 °F)
Dimensions
424 × 133 × 394 mm (16
5
15
/
in.) (w / h / d) not including
8
projecting parts
Mass
Approx. 12.0 kg (26 lb 7 oz)
1)
Teleprompter signals are only compatible with the following cable
lengths.
• 50 to 500 m (Fujikura φ8.5 mm)
• 75 to 750 m (BELDEN 9232 φ13.2 mm)
• 100 to 1,000 m (Fujikura φ14.5 mm)

Input signals

REFERENCE
BNC type (loopthrough)
VBS/BS, 1.0 Vp-p, 75 ohms
2)
RET-1/2
BNC type (1 each, loopthrough)
VBS, 1.0 Vp-p, 75 ohms
2)
PROMPTER
BNC type (loopthrough)
1.0 Vp-p, 75 ohms
3)
SDI RET-3/4
BNC type (1 each)
VBS, 1.0 Vp-p, 75 ohms (terminated
internally)
SDI format, 270 Mbps, SMPTE 259M
2)
The same signal is input to the RET-2 connectors and the
PROMPTER connector.
3)
The signal selection (SDI or VBS) input to the SDI RET-3/4
connectors is switchable.
3
1
/
× 5
/
×
4
4
15
Specifications