DigiTech RP1000 Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} DigiTech RP1000. DigiTech RP1000 2 pagina's. Multi-effects switching system
Ook voor DigiTech RP1000: Installatiehandleiding (12 pagina's)

Pagina afdrukken

WHAT'S IN THE BOX

RP1000 Multi-Effects Switching System & USB Recording Interface

•

Power Supply

GET X-EDIT

To get the X-Edit software, visit

http://digitech.com/en-US/products/RP1000#downloads.

To activate your warranty, please register at

http://digitech.com/en-US/support/warranty_registration.

GET THE OWNER'S MANUAL

Scan the QR code to get the owner's manual or visit

http://digitech.com/en-US/products/RP1000#documentation.

MAKING CONNECTIONS / APPLYING POWER

A. Set your amp(s) to a clean tone, set the

tone controls for a flat EQ response

Live Application

(on most amps, this would be 0 or 5

on the tone controls), turn the volume

control(s) all the way down, then power

off the amp(s). If connecting to a mixer,

fully lower the corresponding channel

fader(s).

B. Make connections as shown in the

diagrams to the right, depending on

application type.

C. Connect the included power supply to

the POWER input jack and plug it into

an available AC outlet.

D. Set the RP1000's MASTER LEVEL

control to 30.

E. Power on your amp(s). slowly raise the

amp volume control(s) for the desired

volume. If using a mixer, adjust each

channel's gain/trim and fader controls

for the desired volume.

A. To bypass effects, press the active 1-5 footswitch. The display will read "BYPASS".

Recording / Practice Application

B. To exit Bypass mode, press the active 1-5 footswitch again.

C. To use the Tuner, press and hold the active 1-5 footswitch for 2 seconds. The display will

briefly read "TUNER" then enter Tuner mode.

D. Play a note on

the guitar. The

note will be

shown in the

display and

arrows in the

display will

indicate if the

note is sharp,

flat, or in tune.

E. To exit Tuner

mode, press

any of the 1-10

footswitches.

BYPASSING EFFECTS & USING THE TUNER

In Tune

Flat

Sharp

Press for Bypass, hold for Tuner