Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Hardware installatiehandleiding - Pagina 17
Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor. Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor 36 pagina's. User guide
Pagina afdrukkenChapter 2
Installing the Cisco ONS 15530
Preventing ESD Damage
Electrostatic discharge (ESD) damage occurs when electronic cards or components are mishandled and
can result in complete or intermittent failures. Note the following guidelines before you install or service
the system:
•
•
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Note
between 1 and 10 megohms (Mohms).
Installing and Removing Line Cards or Motherboards
The line cards and modules used on the Cisco ONS 15530 are hot-swappable. This section describes the
procedures for installing and removing the following line cards and motherboards from the chassis:
•
•
•
•
•
•
•
•
•
•
•
Installing Line Cards or Motherboards
To install a line card or motherboard, follow these steps:
Take the new line card or motherboard from the shipping container.
Step 1
Insert the line card or motherboard carefully into the chassis slot while guiding the upper and lower
Step 2
edges line card or of the motherboard in the tracks until its connectors come into contact with the
backplane.
OL-7706-01
Always wear an ESD-preventive wrist or ankle strap when handling electronic components. Connect
one end of the strap to an ESD jack or an unpainted metal component on the system (such as a
captive installation screw).
Handle cards by the faceplates and edges only; avoid touching the printed circuit board and
connector pins.
Place any removed component on an antistatic surface or in a static shielding bag.
Avoid contact between the cards and clothing. The wrist strap only protects the card from ESD
voltages on the body; ESD voltages on clothing can still cause damage.
ESCON aggregation cards
4-port 1-Gbps/2-Gbps FC aggregation cards
8-port FC/GE aggregation cards
8-port multi-service muxponders
2.5-Gbps ITU trunk cards
10-Gbps ITU trunk cards
10-Gbps ITU tunable trunk cards
10-Gbps uplink cards
Transponder line cards
Carrier motherboards
CPU switch modules
Installing and Removing Line Cards or Motherboards
Cisco ONS 15530 Hardware Installation Guide
2-17