Cisco 2691 Series Installeren en opmaken - Pagina 2

Blader online of download pdf Installeren en opmaken voor {categorie_naam} Cisco 2691 Series. Cisco 2691 Series 34 pagina's. Modular routers
Ook voor Cisco 2691 Series: Gegevensblad (8 pagina's), Gebruikershandleiding (48 pagina's), Snelstarthandleiding (29 pagina's)

Pagina afdrukken
Cisco 2691 Series Installeren en opmaken

Preventing Electrostatic Discharge Damage

Preventing Electrostatic Discharge Damage
CompactFlash memory cards are sensitive to electrostatic discharge (ESD) damage. ESD damage, which
can occur when electronic cards or components are handled improperly, results in complete or
intermittent failures.
Follow these guidelines to prevent ESD damage:
•
•
•
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohms (Mohms).

Tools and Equipment Needed

You need the following tools and equipment to remove and install CompactFlash memory cards:
•
•
•

External CompactFlash Memory Card Installation and Removal

Complete the appropriate procedure below for installing or removing a CompactFlash memory card if
your Cisco router has an external CompactFlash memory card.
If you have questions or need assistance, see the
External CompactFlash memory-card slots are located as shown in
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
2
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
Place a removed CompactFlash memory card on an antistatic surface or in a static shielding bag. If
the card will be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on the body only; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
ESD-preventive wrist strap
Antistatic bag or mat
Number 2 Phillips screwdriver or flat blade screwdriver (only for internally mounted CompactFlash
memory cards)
"Obtaining Technical Assistance" section on page
Figure
1,
March 2002
32.
Figure
2, and
Figure
3.
78-13892-03