Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding - Pagina 23

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 pagina's. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Ook voor Cisco 3020 - Cisco Catalyst Blade Switch: Aan de slag handleiding (31 pagina's), Quickspecs (12 pagina's), Release Release (41 pagina's), Release Release (27 pagina's), Release Release (23 pagina's), Release Release (21 pagina's), Installatiehandleiding (21 pagina's)

Pagina afdrukken

Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding

• Did you wait 30 seconds after you connected

the switch and the PC before you entered the

IP address in your browser?

• Did you enter the wrong address in the

browser, or is there an error message?

Resetting the Switch Module

This section describes how to reset the switch module by rerunning Express Setup. These are reasons

why you might want to reset the switch module:

• You installed the switch module in your network and cannot connect to it because you assigned

the incorrect IP address.

• You want to clear all configurations from the switch module and assign a new IP address.

• You are trying to enter Express Setup mode, and the switch module LEDs start blinking when you

press the Mode button (which means that the switch module is already configured with IP

information).

Resetting the switch module deletes the configuration and reboots the switch module.

Caution

To reset the switch module, press and hold the Mode button. The switch module LEDs begin blinking

after about 3 seconds. Continue holding down the Mode button. The LEDs stop blinking after 7 more

seconds, and then the switch module reboots.

The switch module now behaves like an unconfigured switch module. You can enter the switch module

IP information by using Express Setup as described in the "Running Express Setup" section on page 9.

Accessing Help Online

First look for a solution to your problem in the troubleshooting section of the Cisco Catalyst Blade

Switch 3020 for HP Hardware Installation Guide or the Cisco Catalyst Blade Switch 3020 for HP

Software Configuration Guide on Cisco.com. You can also access the Cisco Technical Support and

Documentation website for a list of known hardware problems and extensive troubleshooting

documentation, including:

• Factory defaults and password recovery

• Recovery from corrupted or missing software

• Switch module port problems

If not, wait 30 seconds, re-enter 10.0.0.1 in the

browser, and press Enter.

If yes, re-enter 10.0.0.1 in the browser, and press

Enter.